彭珮雯黃麗穎2026-05-142026-05-142013-01-26https://203.71.86.71/handle/123456789/14020學位別：碩士 語文別：英文 指導教授：彭珮雯 共同指導教授： 口試委員：許維君;林哲堂 中文關鍵字：二氧化鋯;電腦輔助設計;電腦輔助製作Purpose: The aim of the present in vitro study was to compare the fracture resistance and adhesion of the implant-supported Y-TZP-based single-tooth copings with two different veneering techniques, and evaluate the failure modes after debonding. Methods: A bone level implant (φ3.5 mm, Hung Chun Bio-S Co., Ltd, Kaohsiung, Taiwan) embedded in the mandibular right first molar was selected to receive an all-ceramic Y-TZP-based restoration. All specimens were fabricated by one trained dental technician according to each manufacturer instructions to avoid any operator influence. Three porcelain systems for Y-TZP restorations, CAD-on technology (named as Group CAD), Rapid Layer Technology (named as Group RL) and Conventional hand-layered veneered technique (named as Group CH) were tested. Results: The usage of ligth cure or can-on techniques did not show significant diffenences in the fracture resistance of Zr-based single crowns. The fracture patterns considering partial or total fracture could be observed.系所名稱：醫療器材產業碩士專班thesis